Home arrow Forums



Go Back   XS11.com Forums > Repairs > Brakes

 
 
Thread Tools Display Modes
  #1  
Old 06-17-2002, 03:25 PM
xs11 xs11 is offline
Super Moderator
 
Join Date: Jun 2002
Posts: 130
Master Cylinder Rebuild - Plunger rubber installation

Master Cylinder Rebuild
Plunger rubber installation

by Ken Talbot, 2/26/02


I'm really stumped. Any ideas on how the rubber seal is placed onto the plunger inside the master? It is a small rubber cap and the plunger has a large diameter disk at either end and the seal goes in the middle. The old one is in the center of the plunger and the rebuild kit has the parts separated. At $60 bucks
Canadian I'd hate to mess it up.

Dave Jardine


The rubber seal is quite flexible, Dave, and will take quite a bit of
twisting without tearing apart.


Start with the plunger and seal laid out like this, to be sure of which way the seal is going to face




Roll the seal inside out and slide it up the shaft of the plunger so is comes up against the collar




Slide a flat screwdriver blade under the seal and up onto the collar




Lever the screwdriver over to start bringing the seal into position. Get it far enough over so it won't slip back. Notice how the seal is turning back to right side out as this happens




Use your fingers and thumb to roll the seal the rest of the way over the collar




Check that the seal is sitting in its groove where it belongs.

Voila - you're done!



Last edited by Ken Talbot; 02-27-2009 at 11:49 PM.
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Forum Jump


All times are GMT -6. The time now is 06:21 AM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Integrated by BBpixel ©2004-2019, jvbPlugin