Home arrow Forums



Go Back   XS11.com Forums > Maintenance > Oil & Lubrication

 
 
Thread Tools Display Modes
  #1  
Old 06-16-2002, 05:17 AM
xs11 xs11 is offline
Super Moderator
 
Join Date: Jun 2002
Posts: 130
Greasing the Driveshaft Splines

Greasing the Driveshaft Splines
by Ken Talbot
7/19/00


Here's a short technical note for those who haven't got around to inspecting their rear splines where the drive shaft connects to the final drive.

There is a grease fitting on the driveshaft side that everybody uses for lubing the rear splines. The problem is that the final drive spline slides over the driveshaft. This effectively prevents the grease from getting to the actual contact surfaces of the splines.

Looking forward, here is a shot of the spline on the end of the driveshaft.



Here's a shot of the spline on the final drive.


Look carefully at the face of the splines where the contact actually happens. There's not a whole lot of grease in there at all.

This is why you need to take the final drive completely off once in a while to pack lots of grease inside here where it can do some good.

Last edited by Ken Talbot; 11-14-2009 at 06:31 PM.
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Forum Jump


All times are GMT -6. The time now is 04:28 PM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Integrated by BBpixel ©2004-2019, jvbPlugin