Home arrow Forums



Go Back   XS11.com Forums > Search Forums

Showing results 1 to 25 of 81
Search took 0.06 seconds.
Search: Posts Made By: GoRacers
Forum: XS11/XJ11 Discussion 04-15-2013, 05:50 PM
Replies: 12
Views: 1,441
Posted By GoRacers
No more leaks! Thanks guys.

No more leaks! Thanks guys.
Forum: XS11/XJ11 Discussion 04-14-2013, 12:06 PM
Replies: 12
Views: 1,441
Posted By GoRacers
Ran it for 2-3 minutes today, no leak so far. ...

Ran it for 2-3 minutes today, no leak so far. Ill see if it leajs any overnight.

The float looked like it was rubbing the bowl, and all four were set almost 1/4" high.:eek:

Need to change...
Forum: XS11/XJ11 Discussion 04-13-2013, 11:19 AM
Replies: 12
Views: 1,441
Posted By GoRacers
Great points there. Ill adjust the float...

Great points there.

Ill adjust the float heights and trim the gaskets tomorrow, before i watch golf.;)
Forum: XS11/XJ11 Discussion 04-10-2013, 09:53 AM
Replies: 12
Views: 1,441
Posted By GoRacers
I did not adjust them. The bike runs great...

I did not adjust them. The bike runs great before and after, so I figured I didn't need to touch them.
Forum: XS11/XJ11 Discussion 04-10-2013, 05:37 AM
Replies: 12
Views: 1,441
Posted By GoRacers
Tiny bit of fuel on the floor this morning, not...

Tiny bit of fuel on the floor this morning, not sure if it is the accumulation from yesterday finally dripping down off the case, or if it is fresh. I'll see if there is more when I get home from...
Forum: XS11/XJ11 Discussion 04-09-2013, 06:09 PM
Replies: 12
Views: 1,441
Posted By GoRacers
Floats all move freely. I did tap the bowl with a...

Floats all move freely. I did tap the bowl with a screwdriver handle before coming in from the garage today, ill update this tomorrow with whether or not there is fresh gas on the floor.

I like...
Forum: XS11/XJ11 Discussion 04-09-2013, 05:48 PM
Replies: 12
Views: 1,441
Posted By GoRacers
#2 carb leaking on 78 standard

My #2 carb is dumping gas out of its pod filter when the bike sits (petcocks need to be repaired, they flow gas at all times, no matter the settings).

New float valves and seats, new bowl gaskets....
Forum: XS and XJ 1100 bikes for sale. 01-06-2013, 06:16 PM
Replies: 0
Views: 871
Posted By GoRacers
my 78 is for sale

http://louisville.craigslist.org/mcy/3527006122.html
Forum: Wanted to buy - XS and XJ1100 parts and bikes. 12-08-2012, 05:45 PM
Replies: 4
Views: 754
Posted By GoRacers
Got one, thanks.

Got one, thanks.
Forum: Wanted to buy - XS and XJ1100 parts and bikes. 12-01-2012, 04:17 PM
Replies: 4
Views: 754
Posted By GoRacers
Sent you a message.

Sent you a message.
Forum: Wanted to buy - XS and XJ1100 parts and bikes. 12-01-2012, 01:43 PM
Replies: 4
Views: 754
Posted By GoRacers
need a standard tank

Need a standard tank for a 78
Forum: XS and XJ 1100 parts for sale. 12-01-2012, 01:36 PM
Replies: 8
Views: 1,829
Posted By GoRacers
Bingo. That's where I got mine, from a raptor as...

Bingo. That's where I got mine, from a raptor as well.
Forum: XS and XJ 1100 parts for sale. 12-01-2012, 01:33 PM
Replies: 0
Views: 685
Posted By GoRacers
dent-free 78 standard tank. MAJOR rust.

Have a 78 standard tank I was going to scrap, but figured I'd ask here first. I honestly don't think it can be saved without major repair.

It has no dents, just paint chips. This tank leaks at...
Forum: XS and XJ 1100 parts for sale. 11-18-2012, 06:57 AM
Replies: 21
Views: 3,445
Posted By GoRacers
Pm sent.:D

Pm sent.:D
Forum: XS11/XJ11 Discussion 10-20-2012, 09:06 AM
Replies: 55
Views: 4,368
Posted By GoRacers
Keep some stiff wire and stick magnet handy to...

Keep some stiff wire and stick magnet handy to hold things in place.;)

I pulled the engine and set it on my work bench, so I had all the room I needed :D
Forum: XS11/XJ11 Discussion 10-17-2012, 07:09 PM
Replies: 55
Views: 4,368
Posted By GoRacers
I bought a used trans from andreas for cheap. ...

I bought a used trans from andreas for cheap. Only "special" tool you need is a torque wrench, torx bits, and a soft mallet if I remember correctly.

Not a hard job, and there are TONS of...
Forum: XS11/XJ11 Discussion 10-14-2012, 04:06 PM
Replies: 22
Views: 3,379
Posted By GoRacers
Bled them both again and cleaned up the reservoir...

Bled them both again and cleaned up the reservoir and gasket surfaces before reinstalling the reservoir lid (fluid was seeping out a tiny bit).

Haven't ridden it yet, but the lever is much, much...
Forum: XS11/XJ11 Discussion 10-13-2012, 09:04 AM
Replies: 22
Views: 3,379
Posted By GoRacers
I haven't done much with the front brakes other...

I haven't done much with the front brakes other than swapping master cylinders. Previous owner did the ss lines. I do believe they are working fine, just not enough pressure.

I'm thinking more...
Forum: XS11/XJ11 Discussion 10-12-2012, 10:01 AM
Replies: 22
Views: 3,379
Posted By GoRacers
Good to know. I'm not too educated on...

Good to know. I'm not too educated on differences between years yet, I just read a thread about a linked setup and assumed they were all that way.

I have a 5/8" (pretty much equal to 16mm) MC...
Forum: XS11/XJ11 Discussion 10-12-2012, 06:12 AM
Replies: 22
Views: 3,379
Posted By GoRacers
Front brake M/C options?

Hi all.

I searched a while, but didn't find the exact info I am looking for.

I'm on my 4th front M/C on this 78 xs11. The first two OEM units leaked at the reservoir. Then I went with an...
Forum: XS11/XJ11 Discussion 09-22-2012, 03:41 PM
Replies: 16
Views: 3,395
Posted By GoRacers
Love my supertrapp!

Love my supertrapp!
Forum: XS11/XJ11 Discussion 09-22-2012, 11:45 AM
Replies: 50
Views: 10,702
Posted By GoRacers
Slight hiccup with the trans, had the shifter...

Slight hiccup with the trans, had the shifter linkage misaligned when I put it back together. All is well, now.

Clubman bars REALLY change the bike. I feel much more in control of the bike now. ...
Forum: XS11/XJ11 Discussion 09-22-2012, 11:42 AM
Replies: 50
Views: 6,841
Posted By GoRacers
My shift pawl and lever were misaligned by a...

My shift pawl and lever were misaligned by a tooth.

ALL IS GOOD.:D:D:D:D:D:D

I only put ~3 miles on it, but I can hit the throttle MUCH harder in 2nd than I used to, and it didn't pop out or...
Forum: XS11/XJ11 Discussion 09-16-2012, 04:28 PM
Replies: 50
Views: 6,841
Posted By GoRacers
Perfect. Thanks! Interested in whether I can...

Perfect. Thanks!

Interested in whether I can rotate the drum through all gears manually after pulling the side cover, and whether my shift pawl is attached in the correct position on the drum...
Forum: XS11/XJ11 Discussion 09-16-2012, 03:06 PM
Replies: 50
Views: 6,841
Posted By GoRacers
Got the bike back together today, and I only have...

Got the bike back together today, and I only have two gears.:mad: clutch action and operation is good, I can move the bike with the gears I have, but it will obviously stall if I try to actually...
Showing results 1 to 25 of 81

 
Forum Jump

All times are GMT -6. The time now is 05:59 PM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
Integrated by BBpixel ©2004-2022, jvbPlugin