View Single Post
  #2  
Old 10-01-2011, 03:18 PM
natemoen's Avatar
natemoen natemoen is offline
Master of XSology
 
Join Date: May 2010
Location: Fargo
Posts: 8,624
Seems like you might be doing some things incorrectly.

For the pickup coils I do not remember for sure but your wire colors mentioned do not sound right. The wires to test are going to be the wires on the 4 pin connector, top 2 are one coil and the bottom are the other. You should get a reading of roughly 720 ohms.

For the ignition coils you should be getting around 15k ohms through the spark plug wires with the spark plug caps off. If you have 5k ohm caps like stock then add 10k if the caps are on for the test. Also on the ignition coils you need to check the small wire going into the coils on the back side. Check resistance there as well. If you have 1.5 ohm coils that is what your reading ahould be on those wires, is you have 3 ohm coils then that is what your reading should be.
__________________
Nathan
KD9ARL

μολὼν λαβέ

1978 XS1100E
K&N Filter
#45 pilot Jet, #137.5 Main Jet
OEM Exhaust
ATK Fork Brace
LED Dash lights
Ammeter, Oil Pressure, Oil Temp, and Volt Meters

Green Monster Coils
SS Brake Lines
Vision 550 Auto Tensioner

In any moment of decision the best thing you can do is the right thing, the next best thing is the wrong thing, and the worst thing you can do is nothing.

Theodore Roosevelt
Reply With Quote