View Single Post
  #8  
Old 08-23-2010, 10:14 AM
BigRed BigRed is offline
XStremely XSive
 
Join Date: Mar 2010
Location: Ottawa, Ontario, Canada
Posts: 265
After you get your floats fixed, make sure you do a wet-check on your fuel level in case they changed shape when you popped them back out, or in case you added weight by soldering. All you have to do is hook up a clear 3/16 or 1/4 vinyl line to each carb drain (you can do one at a time), and loop the open end up higher than the carb. Open the drain, and check what the fuel level is against the side of the carb. Make sure you don't have any air bubbles because they'll throw off the measurement.

Good luck!
__________________
'80 SG with motor from a '82 XJ
Reply With Quote