View Single Post
  #10  
Old 08-23-2010, 06:36 PM
Ken Talbot's Avatar
Ken Talbot Ken Talbot is offline
Super Moderator
 
Join Date: Jun 2002
Location: Revelstoke, BC
Posts: 4,251
Quote:
Originally Posted by clcorbin View Post

.... I am confident that each carbs float height was set consistently (my target was 25.7mm using a nice digital caliper back in January).....

.... Either way, I raised the float level to 24.7mm to see if I could lean out the idle mixture screws.
As a point of reference, changing the float levels from 25.7mm to 24.7mm will richen everything overall. As you are having a problem with it being too rich, try resetting the floats again, but this time to 27.7mm Use that as a starting point, being aware that it may actually make things too lean. Start with that, adjust the pilot screws using the "colortune by ear" method, and see where you're at.

Be very careful with that expoy-repaired float post!
__________________
Ken Talbot
Reply With Quote