A Call To All Great Exhaust Builders

[bikerphil]

Originally Posted by Mashermoto

I will say though that even with all 12 discs in place it is much quiter than I thought it would be...which is what I wanted. It has just enough of a mellow growl to please me, but it doesn't make my head rattle going down the road.

However, if you want loud, you can take all the discs off and run it open

Less discs= quieter, richer mixture, more back pressure
More discs= louder, leaner mixture, less back pressure

One time I was running 10 discs in mine (single 4-1 Supertrapp) and all was good for the type of roads in my area. When I reached the twisty roads in NC, I found that I needed more low end grunt. I ran 5 discs increasing back pressure, which gave the bike better low end. You'll find out later that adding and removing discs will change your plug color. Supertrapp, A+ for tunability.

[WMarshy]

How about a 2nd/3rd gear drive by?

[xj11john]

Very nice exhaust, and I like what you've done with the bike too!

[madmax-im]

I found a MAC 4 to 1 on ebay recently and also bought the SuperTrapp Muffler....soon to do this...I'll document it in my own thread...but this thread was most certainly an inspiration!

[R.S.]

Hate to ask the obvious, but why not just clone the OEM pipes - perhaps with a supertrap fitting?

Just take the exact dimensions, and make them?

[cptomlinson]

the bike on this youtube video sounds great! http://www.youtube.com/watch?v=zB2s4mGZsng. he says that he drilled holes in the baffles. would that cause the exhaust temp to go up and damage the engine? anyone know? if it does not hurt anything, how and where would you drill these holes?

[jrotilie]

Hello, I am a tig welder in Ohio, also looking for custom exhaust, about to make my own 4-2 that has both mufflers on the same side similar to harley, if it turns out ok I may consider selling custom setups, but custom work is not cheap.

[IanDMacDonald]

Sounds interesting.

[jrotilie]

Originally Posted by IanDMacDonald

Sounds interesting.

I haven't seen it done on a xs so far, so just gonna wing it, the question is: pie cuts or bend my own tube

[TopCatGr58]

Hey there Jrotilie,

The diameter for the headers are ~1.5", and unless you have a fancy Mandrell bending machine, then it can be a real PITA to manually bend the pipes without stuffing them with sand or such to keep them from collapsing, wrinkling, etc.!

I made a set of headers for a fellow Xsive a couple of years ago, take a look at this thread for hopefully some ideas!?

http://www.xs11.com/forum/showthread...xhaust+project

T.C.

[Bax]

Just throwing it out there.....

Last year I got a replacement exhaust from Heinz Wyes for my SG. Still made per order with long lead time, ordered late Jan 16 and received Sep 16. Excellent materials and craftsmanship. Drop in pipes just have to drill the holes in the support fins.

[IanDMacDonald]

Originally Posted by Bax

Just throwing it out there.....

Last year I got a replacement exhaust from Heinz Wyes for my SG. Still made per order with long lead time, ordered late Jan 16 and received Sep 16. Excellent materials and craftsmanship. Drop in pipes just have to drill the holes in the support fins.

Is that the German stainless system?

[Bax]

Yup. The custom exhaust from Germany.

http://www.xs1100-frw.de/HOMEPAGE_03/Index2.htm

The contact info is in the link.